MOSER ENGINEERING 9″ Rear End Housing with Axles

Description

 

DROP SHIPPED FROM MOSER ENGINEERING

9″ Rear Axle for 1971 to 1989 B Body Cars – Impala, Biscayne, Caprice, Etc.

 

 

 

Below is what is included for $1050:

3″ .250 Wall DOM Axle Tubes (STANDARD) Others charge $30 more

28 – 31 – 35 Spline Axle Options (YOUR CHOICE)

Drive Studs Included 12mm, 1/2-2″,1/2-3″ (YOUR CHOICE)

Housing Vent Included

Wheel Bearings Included

Shipped Bare Steel

We can narrow for free (see Options)

Options for an additional charge:

T-Bolt Brake Hardware Kit (easy install of your stock F Body Backing Plates)

40 Spline Upgraded Axles (Gun Drilled)

5/8″ Wheel Studs

Powder Coat

Fill & Drain Cap

Please call or email us for pricing & estimated time:

We offer full bolt in assemblies

Extreme custom applications (we have done many of these)

Crate & Freight available

International shipping* Our website will not calculate duties/taxes/shipping/broker setups

Important information:

When selecting “differential options” – this is telling us what center section that you already have or are planning on using. The axle lengths will be cut accordingly. If you purchase this for a spool, then later down the road want a clutch lock, S-trac or True Track, etc., etc., one axle may not fit & will need to be trimmed down. Or if you bought this for anything but a spool, & then use a spool center section, the axle could end up being too short on one side. You will not have enough spline engagement.

Axles are shipped with no bearings on them – your stock backing plate needs to go on first then the bearings get pressed on behind them.

Axles are dropped shipped & may show up at an earlier or later time than the housing.