Trick Chassis 9″ Rear axle for 1964 to 1967 Chevelle A body
Below is what comes with it for $1940:
Brand new center fabricated housing can (STANDARD) Others charge $100 more
Internal axle tube gussets (STANDARD) Others charge $75 more
3″ .250 wall DOM axle tubes (STANDARD) Others charge $30 more
4 lower control arm mounting holes (STANDARD)
28, 31, 35 spline axle options (YOUR CHOICE)
Drive studs included 12mm, 1/2-2″,1/2-3″ (YOUR CHOICE)
Housing vent included
wheel bearings included
Shipped bare steel
We can narrow for free (see options)
Complete assembled center section, spool, your choice of gear.
Options for additional charge:
T bolt brake hardware kit (easy install of your stock F body backing plates)
40 spline upgraded axles (gun drilled)
5/8 wheel studs
11 Hole narrowed lower brackets
Rubber installed in upper ears
Spherical aluminum installed in upper ears
Fill and drain caps
Coil over brackets
Coil over brackets with no spring perches added
Please call or email us for pricing and estimated time:
We offer full bolt in assemblies
Extreme custom applications (we have done many of these)
Crate and freight available
International shipping* Our website will not calculate dutys/taxes/shipping/broker setups.
Axles are shipped with no bearings on them. Sometimes depending on what brakes you will use, your brake backing plate needs to go on first then the bearings get pressed on behind them.
Axles and center section are dropped shipped and may show up at an earlier or later time than the housing.
Please see the brakes that we offer. If you have questions please call, email, or chat with us.